mindervova.blogg.se - Seaiq nautical

Seaiq nautical Bluetooth#

Vessel Motion (Only SEA iq Pilot) : This controls whether to display a section in the status bar displaying vessel motion. This should only be enabled if you know your ROT sensor has the required level of precision. Precise Rate of Turn (Only SEA iq Pilot) : When enabled, ROT is shown with an extra degree of precision ( 10.1°/m).

This should only be enabled if you know your course sensor has the required level of precision. Precise Course (Only SEA iq Pilot) : When enabled, course is shown with an extra degree of precision ( 359.9°).When this and Settings / Alarms / Heading Tick are enabled, then the ticks are made on 1/2°. This should only be enabled if you know your heading sensor has the required level of precision. Precise Heading (Only SEA iq Pilot) : When enabled, heading is displayed with an extra degree of precision ( 359.9°). Information shown includes: satellite system, satellite number, elevation, azimuth, and signal to noise ratio. This information is normally only available when using an NMEA feed with xxGSV sentences. : This controls display of GPS satellite information (when available). GSP: Geoidal separation (difference between MSL and WGS84 geode.ALT: Altitude above mean-sea-level (MSL).If altitude is provided, then it is displayed as follows: : This controls display of GPS diagnostic information, such as the fix type (GPS, DGPS, etc), HDOP, HPE, number of satellites, etc. This setting also controls the GPS validation data. It can be useful to not have latitude and longitude displayed in order to reduce clutter. : This controls whether the GPS position should be displayed in the status bar on the side of the display. Wake Screen / On Screen Wake Show Last App / Alwaysįor further information, please see detailed help information in the SEA iq Watch app.Wake Screen / On Tap / Wake for 70 Seconds.Wake Screen / Wake Screen On Wrist Raise.We suggest making the following settings on your iPhone Watch App by choosing your watch and going to the General settings: If information is not appearing, check the status displayed in SEA iq Watch on your iPhone.

Seaiq nautical Bluetooth#

You will be asked if you will allow use of Bluetooth select Yes.

Turn on Settings / Status Bar / Apple Watch (this setting).

Run SEA iq Pilot or SEA iq Pilot VPP on your iPad.

Steps to use your Apple Watch with SEA iq Pilot: SEA iq Watch is required because your iPhone is paired with your watch and SEA iq Pilot is normally run on iPads. The normal operation is to run SEA iq Pilot (or SEA iq Pilot VPP) on your Apple iPad and SEA iq Watch on your iPhone. SEA iq Watch provides a number of status displays, including ROT/HDG/COG/SOG, SOG-only, Vessel Motion, and Docking. This is intended to be used for display on an Apple Watch by running the companion app, SEA iq Watch. This automatically disables itself whenever SEA iq restarts.Īpple Watch (Only SEA iq Pilot) : When enabled, data will be made available on Bluetooth for access by other devices. Note that only currently visible panels may be reordered. After turning this on, go to the status bar, re-order the panels, then come back and turn this off. : When enabled, the panels in the vertical status bar can be graphicly reordered. You can also select these using the buttons on the top and left/right These settings control which status bars are displayed.

Horizontal Status Bar: This is shown along the top of.

Data is also shown in a context-sensitive fashion.įor instance, when AIS is enabled the most recently selected AIS Available data is logically grouped together andįont-size is used to emphasize more important information so it isĮasier to read.

Vertical Status Bar: This is shown along the side of theĭisplay.Right side of the display and a horizontal bar on the top of the There are two different status bars a vertical bar on the left or SEA iq uses status bars for presenting sensor data and other